Caution
- Never cover a wet vehicle
- Not liable for repainted surfaces or lacquer paint
- Do not cover the tail pipe or exhaust
- A hot exhaust and muffler can burn you and melt your cover
- Be sure the hood and engine are cool before you put on your cover
- Never cover a convertible with the top down
- Do not spread cover across an open sunroof or t-roof

This cover is designed to be water repellent but it will not prevent water from reaching the surface of your vehicle.

Installation
Remove or retract your antenna. If you have a fixed antenna see below. Your storage bag is attached with a leash to the back of your cover. Insert the storage bag in your trunk near the center latch and close the trunk. This will help protect the cover from theft and anchor the cover for easier fitting. Pull your cover over the roof from the back to the front. Drop your cover over the sides, then fit the elastic hem of your cover under the front bumper of your vehicle. Secure your cover under the rear bumper and corners. To secure your cover on your vehicle, attach one end of the supplied rope to a web loop set in the side of your cover.
Toss the rope under the vehicle and tie the rope to the web loop on the opposite side. For extra security you may also use a cable lock in these web loops (cable lock not supplied).

Antennas
Check your antenna—many antennas simply unscrew at their base. If your antenna cannot be removed or retracted, you will need to make a small hole in your cover for it. Put your cover on as much of your vehicle as you can without covering the antenna. Mark the area where your cover will go over the antenna. With a sharp pencil or pen, carefully push a small hole in your cover. Peel the backing from your antenna patch and, centering the hole in the patch over the hole in your cover, adhere the patch to your cover. Press the patch down firmly. Carefully lift your cover down over your antenna, threading your antenna through the hole, and finish fitting your cover.

Care
Clean your cover with a soft brush and lukewarm water or machine wash in COLD water. DO NOT USE SOAP as it may remove the protective coating added by the factory. Line dry only; do not machine dry. Avoid trapping moisture under your cover. If your vehicle is outside for long periods or under snow, trapped moisture can sometimes cause paint to become cloudy. We recommend removing your cover every 30 days. Let your vehicle dry completely before reinstalling your cover.

Storage
A handy storage bag is provided for your cover. Be sure the cover is completely dry before you store it in the storage bag for an extended period.

Two Year Warranty
This product is factory warranted for workmanship and materials for two years after purchase. Trailering or use during transportation of your vehicle will invalidate this warranty.